Nebula Nr5101; Nebula Nr7101 - ZyXEL Communications Nebula LTE3301-PLUS User Manual

2.3.3 Nebula NR5101

Figure 14 Nebula NR5101
The following table describes the ports and buttons on your Nebula NR5101.
Table 11 Nebula NR5101 Panel Ports and Buttons
LABELS
ANT1-ANT2 / Antenna
USB
LAN2/WAN
LAN1
WiFi
RESET
POWER Button
POWER
Micro SIM
INT/EXT

2.3.4 Nebula NR7101

Figure 15 Nebula NR7101
Chapter 2 Hardware Panels
DESCRIPTION
Install the external antennas to strengthen the cellular signal.
Note: To use the external antennas, you must set the INT/EXT switch to EXT.
The USB port of the Zyxel Device is used for file sharing.
LAN mode: Connect a computer to the LAN using an RJ45 cable.
WAN mode: Connect the Zyxel Device to the Internet through the WAN.
Connect a computer to the LAN using an RJ45 cable.
Press for 1 second: Enable or disable WiFi.
Press for more than 5 seconds: Activate WPS connection process.
Press for 2 seconds: Reboot the Zyxel Device.
Press for 5 seconds: Restore the Zyxel Device to its factory default settings.
Press the POWER button after the power adapter is connected to start the Zyxel Device.
Connect the power adapter and press the POWER button to start the Zyxel Device.
Insert a micro-SIM card into the slot with the chip facing down and the beveled corner
in the top left corner.
Select between the internal or external cellular antennas.
Nebula Mobile Router User's Guide
33