Cellular Lock (5G) - ZyXEL Communications Nebula LTE3301-PLUS User Manual

Figure 75 Network Setting > Broadband > Cellular Lock (LTE)
The following table describes the fields in this screen.
Table 38 Network Setting > Broadband > Cellular Lock (LTE)
LABEL
LTE(4G) Lock Management
PCI Lock
Add New Rule
Physical Cell ID
RFCN
Delete
Cancel
Apply

7.11.2 Cellular Lock (5G)

Use this screen to configure cellular lock on Zyxel Devices that use 5G NR connections.
To lock a base station identified by its Physical Cell ID and band, go to Network Setting > Broadband >
Cellular Lock (5G).
Note: Enabling/Disabling Cellular Lock will make the WAN connection to be temporarily
disconnected.
Note: 5G (NR) Cellular Lock only works when the Zyxel Device is using the NR5G-SA mode.
Make sure the Preferred Access Technology on the Network Setting > Broadband >
Cellular Band screen is set to NR5G-SA or NR5G-SA/NR5G-NSA/SG (Auto Switch).
Chapter 7 Broadband
DESCRIPTION
Click the switch button (to the right) to enable PCI (Physical Cell Identifier) Lock on base
stations when the Zyxel Device has 4G LTE connections. Physical Cell ID (PCI) is an
identifier for a cell, namely a cellular base station. PCI and Radio Frequency Channel
Number (RFCN) are combined to specify the base station.
Click to add a new cellular lock rule.
Enter the PCI number (0 – 504) of the base station to which you want the Zyxel Device to
connect.
Enter the RFCN (Radio Frequency Channel Number) for the LTE frequency of the
specified PCI (1 – 65535).
Click the Delete icon to remove an entry.
Click this to return to previous settings without saving.
Click this to save and apply your changes.
Nebula Mobile Router User's Guide
128