ZyXEL Communications Nebula LTE3301-PLUS User Manual page 96

Table 21 Cellular Info: Detailed Information (continued)
LABEL DESCRIPTION
Enable This shows if GNSS is enabled.
Note: This can only be configured by a qualified service technician.
Scan This shows Enable if Scan OnBoot is enabled, so that GNSS runs automatically after the Zyxel
OnBoot
Device is turned on.
Note: This can only be configured by a qualified service technician.
Scan Status This shows GNSS error codes for debugging by a qualified service technician.
HDOP Horizontal Dilution of Precision (HDOP) shows how accurate data collected by the Zyxel Device
is according to the current satellite configuration. A smaller value of HDOP means a higher
precision.
Display This shows the latitude and longitude display modes. There are three modes: 0, 1, and 2.
Format
Below are examples for these modes shown in latitude/longitude.
0 - ddmm.mmmmN/S, dddmm.mmmmE/W
1 - ddmm.mmmmmm, N/S, dddmm.mmmmmm, E/W
2 - (-)dd.ddddd, (-)ddd.ddddd
N/S/E/W: North/South/East/West
"-" : Negative values refer to South latitude/West longitude respectively. Positive values refer to
North latitude/East longitude.
Latitude This shows the latitude coordinate of the Zyxel Device. These positioning values (latitude,
longitude, and altitude) help you locate the Zyxel Device accurately.
Longitude This shows the longitude coordinate of the Zyxel Device.
Elevation This shows the altitude of the Zyxel Device above sea level in meters.
Positioning This shows the GNSS positioning mode. 2D ("2") GNSS positioning mode displays latitude and
Mode
longitude co-ordinates; 3D ("2") GNSS positioning mode displays latitude and longitude co-
ordinates, and elevation.
Course over This shows the course of the Zyxel Device based on true North. Course Over Ground (COG) is
ground
different from the direction an object is headed, but the path derived from its actual motion
(considered as Track), since the motion of an object is often with respect to other factors like
wind and tides.
Speed Over This shows the Speed Over Ground (SOG) of the Zyxel Device. SOG is the true object speed over
Ground
the surface of the Earth.
Last Fix Time This shows the last time in UTC format that the position of the Zyxel Device was updated.
Number Of This shows the number of current active satellites. GNSS requires at least 4 satellites to determine
Satellites
the position of the Zyxel Device.
Service Information
Note: If the cellular service provider supports carrier aggregation (CA), then this section displays
statistics for the connection's primary component carrier (PCC).
Access This displays the type of the mobile network (such as LTE, UMTS, GSM) to which the Zyxel Device is
Technology connecting.
Band This displays the current cellular band of your Zyxel Device (WCDMA2100).
RSSI This displays the strength of the cellular signal between an associated cellular station and the
Zyxel Device.
Chapter 6 Connection Status
Nebula Mobile Router User's Guide
96