3
Installing the Module
Installing the Valve Heads
1
The two different pins (blue & green) on the valve shaft
must fit into the corresponding grooves of the actuator
axis. The outside pin (red) must fit into the outside
groove.
46
2
a
It can be possible that you have to turn the valve
head until the outside pin completely locks in.
While turning the valve you should feel some
resistance from the drive. Otherwise the pins on
the valve shaft are not properly fitted into the
corresponding adapters on the valve drive.
b
It can be possible that you have to turn the valve
head until the outside pin completely locks in.
While turning the valve you should feel some
resistance from the drive. Otherwise the pins on
the valve shaft are not properly fitted into the
corresponding adapters on the valve drive.
Agilent 1290 Infinity Valve Drive and Valve Heads