Agilent Technologies 1290 Infinity User Manual page 38

3
Installing the Module
Installing the Valve Drive
Mounting the Valve to an Instrument by Using a Valve Rail
"Defective on arrival" problems
C A U T I O N
If there are signs of damage, please do not attempt to install the module. Inspection by
Agilent is required to evaluate if the instrument is in good condition or damaged.
➔
➔
The Installation of the leak tray and the external leak sensor is optional.
N O T E
If you want to attach the leak tray to the valve drive you need to slide the leak tray on to the
valve drive before having both clamps attached to the valve drive.
1
Ensure the power switch at the rear of the module is OFF
and the power connector is unplugged.
38
Notify your Agilent sales and service office about the damage.
An Agilent service representative will inspect the instrument at your site and
initiate appropriate actions.
2
Identify the marks for the screws on the side panel of the
cabinet assy and screw the valve rail to the side panel of
the cabinet.
Agilent 1290 Infinity Valve Drive and Valve Heads