Table of Contents
Advertisement
Software
Revision E
Maintenance: Disassembly Guidelines
After replacing the CPU board, you need to install or update the software on the
board as follows:
1.
Connect the system to AC power.
Keep the system connected to AC power during the software update and do not
power off the system during the software update.
2.
Press Power to turn on the system.
3.
From the Main Menu, select System Setup.
4.
Enter the system password. and press Enter.
5.
Press Shift + F3.
The following message is displayed.
Please Insert SD Card
Press 'Esc' to cancel
6.
Insert the secure digital card with the application software.
A message similar to the following displays.
Current Version:
New Software Version:
Press 'Enter' to start installation
7.
Press the Enter key.
A series of messages that describe the update process displays.
Copying code to Main Memory...
Erasing Flash...Please Wait
Programming Flash: 10 %
One of three things happens at this point:
If the boot code is not being updated, the following message displays:
Programming Over
System is Shutting Down
If the boot code is being updated to a newer version, the following
messages display:
MAC 5500 resting ECG analysis system
2020299-020
5-15
Advertisement
Table of Contents
