6 Mechanical Installation
WARNING
Crush Hazard. When you lift the drive during installation or removal, do not try to turn the drive over and do not
ignore the hanging drive. If you move a hanging drive too much or if you ignore it, the drive can fall and cause serious injury or
death.
WARNING
Crush Hazard. When you install the drive, do not hold the front cover. Install the drive with holding the heatsink. If
you hold the front cover, the cover will come off and the drive will fall, then it can cause injury.
◆
Installation Position and Clearances
Install the drive vertically for sufficient airflow to cool the drive.
Note:
Contact Yaskawa or a Yaskawa representative for more information about installing drive models on their side.
A - Vertical installation
■
Install Single Drive
Use the clearances specified in
airflow to cool the drive.
A - 50 mm (2 in) minimum
B - 30 mm (1.2 in) minimum on each side
◆
Removing/Reattaching Covers
This section gives information about how to remove and reattach the front cover and terminal cover for wiring and
inspection.
Different drive models have different procedures to remove and reattach the covers. Refer to
information.
Model
T103 - T168
T208 - T720
16
Figure 6.1 Installation Orientation
Figure 6.2
to install the drive. Make sure that there is sufficient space for wiring and
Figure 6.2 Installation Clearances for One Drive
Table 6.3 Procedures to Remove Covers by Drive Model
Procedure
Procedure A
Procedure B
B - Horizontal installation
C - 120 mm (4.7 in) minimum above and below
D - Airflow direction
YASKAWA TOEPC71061782C GA800 Drive Installation & Primary Operation
Table 6.3
for more
Reference
17
18