Table of Contents
Advertisement
U3042AE08
8. To launch the Cal Set Viewer toolbar. Select Response > CAL > Manage CALS >
CAL Set Viewer.
Figure 44 Calibration, Cal Set Viewer
9. From the Cal Sets drop-down menu, select 999.1 and check Enable. Select the
Reflection Tracking(1,1) term in the center drop-down menu and ensure that the
Enable and Error Terms are selected.
NOTE
Figure 45
50
This Manual:http://www.manuallib.com/agilent/u3042ae08-test-set-user-guide.html
You may also create a table on the analyzer which enables you to enter the
limit line stimulus and response values. Select Limit Test ON and Limit Line
ON, and press Show Table. See
Setting the Test Limits
Figure
45.
User's Guide U3042-90002
Operational Check
Advertisement
Table of Contents
