Agilent Technologies U3042AE08 User Manual page 22

U3042AE08
4. Remove the two standoffs and screws (0515-1619) from the rear panel on the test set.
5. Install the top left and right rear locking feet from the kit (5063-9253) using screws
(0515-1244).
Figure 8
6. Place the network analyzer on top of the test set and ensure that the front frame of the
network analyzer is positioned slightly forward of the locks that are attached to the test
set. Slide the network analyzer back so the locks engage the front frame of the analyzer.
Figure 9
7. Secure the network analyzer's lower locking feet to the test set upper locking feet, using
the spring–loaded screws on the locking feet. Refer to
analyzer's lower locking feet are not aligned with the screw holes in the test set's upper
locking feet, loosen the screws securing the feet to the instrument slightly to align.
User's Guide U3042-90002
This Manual:http://www.manuallib.com/agilent/u3042ae08-test-set-user-guide.html
Rear Locking Feet
Test Set
Interface
Locking the Analyzer's
Lock Link
Test Set
Front Frame
Pass Thru
Interface
Network Analyzer
Front Frame
Slide the network Analyzer
screw
back to engage the lock link
in the back of the network
analyzer's front frame
Figure
System Setup with N5230C
10. If the network
13