Connector Care And Cleaning Precautions - Agilent Technologies U3042AE08 User Manual

U3042AE08
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING

Connector Care and Cleaning Precautions

Remove the power cord to the instrument. To clean the connectors use alcohol in a well
ventilated area. Allow all residual alcohol moisture to evaporate, and fumes to dissipate
prior to energizing the instrument.
WARNING
WARNING
64
This Manual:http://www.manuallib.com/agilent/u3042ae08-test-set-user-guide.html
These servicing instructions are for use by qualified personnel only. To
avoid electrical shock, do not perform any servicing unless you are
qualified to do so.
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended. Discard used
batteries according to manufacturer's instructions.
For continued protection against fire hazard replace line fuse only
with same type and rating. The use of other fuses or material is
prohibited.
These servicing instructions are for use by qualified personnel only.
To avoid electrical shock, do not perform any servicing unless you
are qualified to do so.
The opening of covers or removal of parts is likely to expose the user
to dangerous voltages. Disconnect the instrument from all voltage
sources before opening.
No operator serviceable parts inside. Refer servicing to qualified
personnel. To prevent electrical shock, do not remove covers.
The detachable power cord is the instrument disconnecting device. It
disconnects the mains circuits from the mains supply before other parts of
the instrument. The front panel switch is only a standby switch and is not a
LINE switch (disconnecting device).
To prevent electrical shock, disconnect the
U3042AE08" from mains electrical supply before cleaning. Use a dry cloth or
one slightly dampened with water to clean the external case parts. Do not
attempt to clean internally.
If flammable cleaning materials are used, the material shall not be stored,
or left open in the area of the equipment. Adequate ventilation shall be
assured to prevent the combustion of fumes, or vapors.
Safety and Information
"Agilent Technologies
User's Guide U3042-90002