Agilent Technologies U3042AE08 User Manual page 26

U3042AE08
4. Install the two rear locking feet onto the test set. Looking at the front panel, the
N5242-20138 is the right foot and the N5242-20139 is the left foot. Two screws
(0515-2317) are included with this option. Refer to
Figure 14
5. Place the network analyzer on top of the test set and ensure that the front frame of the
network analyzer is positioned slightly forward of the locks that are attached to the test
set. Slide the network analyzer back so the locks engage the front frame of the analyzer.
Refer to
Figure 15
User's Guide U3042-90002
This Manual:http://www.manuallib.com/agilent/u3042ae08-test-set-user-guide.html
Install Locking Feet on U3042AE08
Figure 15.
Locking the Analyzer's
Lock Link
Figure
Network Analyzer
Front Frame
screw
Test Set
Front Frame
System Setup with N5242A
14.
Slide the network Analyzer
back to engage the lock link
in the back of the network
analyzer's front frame
17