U3042AE08
System Setup with N5242A
WARNING
Preparing the N5242A Network Analyzer
1. Remove the feet from the bottom of the network analyzer. Refer to
2. Remove the 2 lower standoffs and screws (0515-1619) from the rear panel on the
network analyzer. Refer to
Figure 12
3. Install the two rear locking feet (5023-0132) onto the PNA-X, using the included screws
(0515-1619), where the standoffs were removed. Refer to
Figure 13
Screws (0515-1619)
Included in package
16
This Manual:http://www.manuallib.com/agilent/u3042ae08-test-set-user-guide.html
The opening of covers or removal of parts is likely to expose
dangerous voltages. Disconnect the instrument from all voltage
sources while it is being opened.
Figure
Rear Bottom Feet
Standoffs (x2)
Feet (x4)
Install Locking Feet on N5242A
12.
Figure
System Setup with N5242A
Figure
12.
13.
Locking Feet
(5023-0132)
User's Guide U3042-90002