Managing The Rfid Reader For User Authentication - AGFA DR 100s User Manual

Managing the RFID reader for user authentication

In order for a user to be able to start the X-ray system and to log in to
Windows, using his personal RFID key, the user must be configured on the DR
100s.
Each RFID key must be linked to a Windows user account.
Multiple RFID keys can be linked to the same Windows user account.
An RFID key can be configured on more than one DR 100s system.
There are two special types of RFID key:
• Start-up only RFID key
This key is not linked to a Windows user account and cannot be used to log
in to Windows. These keys can be used by hospital personnel who must be
able to move the X-ray system, but who are not allowed to access the
patient data or perform X-ray exposures.
• Master RFID key
This key is not linked to a Windows user account and cannot be used to log
in to Windows. These keys are not intended for daily use. They should be
stored in a safe place and may be needed by a service engineer for
managing the RFID configuration.
Supported cards or tags:
• TOPAZ (NFC Forum T1T)
• NTAG213 / 216 (NFC Forum T2T)
• Sony Felica (NFC Forum T3T)
• MIFARE Plus, ULTRALIGHT, DESFIRE (ISO-DEP, NFC Forum T4T)
• MIFARE Classic
• ICODE (IEEE-15693 SLI) tags.
Topics:
• Adding an RFID key card to the configuration of the RFID reader
• Adding a start-up only RFID key card to the configuration of the RFID
reader
• Updating the configuration of a user
• Removing an RFID key card from the configuration of the RFID reader
• Copying the configuration of the RFID reader to another DR 100s
system
DR 100s | Advanced Operation | 139
0411D EN 20220627 1040