Note To The User - AGFA D2RS User Manual

Digital Remote Controlled Table with dynamic flat panel detector
User's Manual
In normal use, (detector integrated into the table as image receptor) the reference axis of the X-ray beam must
form an angle of 90 ° with the surface of the tabletop, so that the X-ray beam corresponds to the image area. There
is an indexing system, activated by the buttons on the tube cover that automatically positions the X-ray tube
assembly at 0°, + / -90° and 180°.
Be sure that in normal use (detector in the table) the X-ray tube assembly is well positioned at 0 ° with the indexing
system.

NOTE TO THE USER

Your X-ray department has just purchased a Digital Dynamic Remote System with flat panel detector.
We congratulate you on this choice, and are sure you will be fully satisfied with its use and diagnostic capabilities.
These radiology units offer high quality and advanced technology.
To become familiar with its operation and make the most of its performance, the use of this equipment is conditioned
by the initial training received during approximately 5 days, depending on the X-ray service requirements, provided
during entry into service as well as the careful reading and understanding of the full user manual.
Read all documentation before using the medical device.
Keep this manual with the others in a safe place so that you can easily refer to it in the future.
Thank you for your confidence.
6