Omron Z4LB V2 Instruction Manual page 57

Setting Thresholds
LOW Threshold Setting
Displaying Negative Values
80.500
Press the Up Key.
90.500
Press the Up Key.
0.050
Bank Selection
If the bank selection is enabled, the screen to select the bank
number appears after the operating mode selector is set to H or
L. Set the thresholds after setting the bank number.
→
Refer to 4-2-5 Enabling the Bank Selection (p. 44).
Procedure
The value will be entered and the indicator will flash twice.
8 Set the operating mode selector to L.
The LOW indicator will flash and the display will show the
present LOW threshold.
9 Take steps similar to steps 5 and 7 to set the LOW threshold.
Locate the cursor to the leftmost digit
and press the Up Key until the value
changes to 9.
Press the Up Key once again. The
negative symbol will appear.
1 Set the operating mode selector to H or L.
The bank number will be displayed and the HIGH or LOW
indicator will flash.
2 Press the Up Key and select the bank number where the
threshold will be set.
bank1
Bank 1
3 Press the SET Key.
The bank number will be entered and the display will show
the present threshold.
4 Set the HIGH or LOW thresholds.
bank2
Bank 2
Section 3-2
33