Omron Z4LB V2 Instruction Manual page 33

Inspection for Loose Bottle Caps
LOW Threshold Setting
Teaching value of reference workpiece
1-1-5 Detection
The following information is the same for both Standard and
One-side Interruption High-precision Sensors.
Set the operating mode selector to RUN.
The Sensor will start taking measurements and the indicator will
turn ON at the preset threshold value.
8
5 Press the SET Key.
The set value will be entered and the value will flash twice.
6 Set the operating mode selector to L.
The LOW indicator will start flashing and the present LOW
threshold will be displayed.
7 Take steps similar to 2 and 5 to set the LOW threshold.
The LOW threshold obtained from the teaching value minus
an approximate value of 0.7% F.S. will be displayed.
LOW threshold
Section 1-1