Omron Z4LB V2 Instruction Manual page 28

Inspection for Loose Bottle Caps
Operation Flow
1-1-1 Wiring and Connections
The following information is the same for both Standard and
One-side Interruption High-precision Sensors.
→
V/mm
Emitter
Item
1-1-1 Wiring and Connections
1-1-2 Axis and Gain Adjustments
1-1-3 Setting Measurement Unit
1-1-4 Setting Thresholds
1-1-5 Detection
1 Wire and connect the sensor components as shown below.
Refer to 2-2 Wiring (p. 14) and 2-3 Connections (p. 18).
Amplifier
Receiver
2 Turn ON the power.
Applicable Sensors
Standard and One-side
Interruption High-precision
Standard
Standard
Standard and One-side
Interruption High-precision
Standard and One-side
Interruption High-precision
Brown (12 to 24 VDC)
Blue (0 V)
White (HIGH/PASS output)
Gray (LOW/NG output)
Black (1- to 5-V linear output)
Shield (Linear GND)
Green (Bank selection input)
Purple (Timing input)
Red (Hold reset input)
Orange/Purple (Forced-zero input)
Pink (LD OFF input)
Section 1-1
3