HP OmniBook 2000 Evaluator Manual page 75

5. Click Yes to begin the Windows NT Network Installation.
6. Enter the directory of the Windows NT 3.51 installation files (D:\i386 if installing
7. Select Do Not Detect in the Network Adapter Card Detection window.
8. Click Continue.
9. Select <Other> Requires disk from manufacturer, then click Continue.
10. Insert the Xircom Drivers Disk, then click OK to accept A:\.
11. Click OK to accept Xircom CreditCard Ethernet IIps.
12. Enter the settings listed above in the Xircom CreditCard Ethernet IIps Setup
13. Select the Protocols to install, then click Continue.
14. If you installed the TCP/IP protocol, you will be prompted for the TCP/IP
15. Click OK at the Network Settings window.
16. If you installed the TCP/IP protocol, and you chose not to use DHCP, you will
17. Click OK at the Network Setup Warning message window.
18. Click No to continue with the installation.
19. Enter the Workgroup name, then click OK.
Note If you need to connect to a domain, you will not be able to input the name at this
time. Restart the OmniBook. Under Network Setup, enter the domain name.
20. When prompted, click Restart Computer.
21. From Control Panel, double-click Network.
22. Type the correct Domain Name, then click OK.
23. When prompted, click Restart Computer.
from CD-ROM).
v1.33 window, then click Continue.
installation options. Select the appropriate choices for your network.
be prompted to enter your TCP/IP information.
If you need to enter a domain name, continue with the following 3 steps.
Using Windows NT 3.51
Installing Cards
4-9