Installing Windows NT 3.51
This section describes how to set up the operating system and drivers including the
following:
Disabling the infrared port.
Installing Windows NT 3.51.
Installing video support.
Installing sound support.
To disable infrared
Windows NT 3.51 does not support infrared communications. Disable the infrared
port on the OmniBook to free COM2 for your modem.
1. Restart the OmniBook.
2. Press F2 when prompted to enter the System Configuration Utility (SCU).
3. Choose COM Ports from the Input/Output menu.
4. Change the IR port to None.
5. Save and Exit the SCU.
To install Windows NT 3.51
1. Connect the ac adapter to the OmniBook.
2. Connect the disk drive to the parallel port and insert the Setup Book disk.
3. Insert the OmniBook's internal CD ROM into the expansion bay.
4. Restart the OmniBook.
5. When prompted, insert Disk 2 in the floppy disk drive, then press Enter.
6. Insert the Windows NT 3.51 CD.
7. Press Enter at the Windows NT Workstation Setup Welcome screen.
Using Windows NT 3.51
Installing Windows NT 3.51
4-3