To Install Video Support - HP OmniBook 2000 Evaluator Manual

28. Enter the Administrator password twice, then click Continue.
29. Enter your user name and password. If you are connecting to a network, get
30. Enter your password again to confirm, then click Continue.
31. Click Continue to accept MS-DOS Editor.
32. Enter the correct Time Zone and Date and Time, then click OK.
33. Click OK at the Detected Display window.
34. Click OK at the Display Settings window. (The video driver will be installed in
35. Click Yes to create an Emergency Repair Disk.
36. Insert a blank floppy disk, then click OK.
37. Remove the floppy disk, then click Restart Computer.

To install video support

Requirements
Important The Windows NT 3.51 drivers must be installed from disk. If you have formatted
your hard disk drive and are using the Recovery CD copy the \OMNIBOOK directory
from the Recovery CD to the hard disk drive.
1. From Control Panel, double-click Display, then click Change Display Type.
2. Under Adapter Type, click Change.
3. Click Other.
4. Enter the correct directory of the Windows NT 3.51 OmniBook 2000/5700 video
5. Select the Chips Video Accelerator(64300,64310,65545,65548,65550), then click
This password is used to administer User IDs and Windows NT security.
these from your network administrator.
the next section.)
OmniBook 2000/5700 with Windows NT 3.51 installed.
OmniBook 2000/5700 drivers for video support.
Location: OmniBook hard drive or Recovery CD in
\OMNIBOOK\DRIVERS\NT\VIDEO.351.
drivers, then click OK.
Install.
Using Windows NT 3.51
Installing Windows NT 3.51
4-5