To Install An Intel Etherexpress Pro/100B Pci Lan Adapter - HP OmniBook 2000 Evaluator Manual

11. Click OK to accept the 3Com EtherLink III LAN+336 Modem PC card (3C562).
12. Enter the settings listed above in the EtherLink III LAN+336 Modem PC card
13. Select the Protocols you wish to install, then click Continue.
14. If you installed the TCP/IP protocol you will be prompted for the TCP/IP
15. Click OK at the Network Settings window.
16. If you installed the TCP/IP protocol and you chose not to use DHCP you will be
17. Click OK at the Network Setup Warning message window.
18. Click No to continue with the installation.
19. Enter the Workgroup name, then click OK.
Note If you need to connect to a domain, you will not be able to input the name at this
time. Restart the OmniBook. Under Network Setup, enter the domain name.
20. When prompted, click Restart Computer.
21. From Control Panel, double-click Network.
22. Type the correct Domain Name, then click OK.
23. When prompted, click Restart Computer.
To install an Intel EtherExpress PRO/100B PCI LAN
adapter
Requirements
This procedure assumes that Windows NT Networking has not been installed.
V1.60 window, then click Continue.
Installation options. Select the appropriate choices for your network.
prompted to enter your TCP/IP information.
If you need to enter a domain name, continue with the following 3 steps.
OmniBook 2000/5700 with Windows NT 3.51 installed.
Intel EtherExpress PRO/100B PCI LAN Adapter.
Windows NT 3.51 CD-ROM.
Intel Drivers Disk.
Using Windows NT 3.51
Installing Cards
4-11