To Install Video Support - HP OmniBook 2000 Evaluator Manual

23. Enter an Administration password twice, then click Next. This password is used
24. Choose Yes, create an emergency repair disk, then click Next.
25. Choose Install the most common components, then click Next.
26. Click Next to Install Windows NT Networking.
27. Choose Do not connect the computer to a network at this time, then click Next.
Important We recommend that you install Windows NT networking after Windows NT is fully
installed. Follow the instructions in the application note for the network card you
are using. The application notes are available from our website. A few sample
application notes are also included at the end of this chapter.
28. Click Finish to finish setting up Windows NT.
29. Enter the correct Time Zone and Date and Time, then click Close.
30. Click OK twice to accept the VGA-Compatible Display Adapter (The video
31. Insert a blank disk in the floppy disk drive, then press Enter.
32. Remove the disk from the floppy disk drive and label it
33. Press Enter to reboot.

To install video support

Requirements
1. From Control Panel, double-click Display, then click Settings.
2. Click Display Type, then click Change.
3. Click Have Disk in the Change Display window.
4. Enter the directory of the video drivers, then click OK.
to administer User IDs and Windows NT security.
driver will be installed in the next section.)
"OmniBook Windows NT 4.0 Emergency Repair Disk"
OmniBook 2000/5700 with Windows NT 4.0 installed.
OmniBook 2000/5700 driver for video support.
Location: OmniBook hard drive or Recovery CD in
\OMNIBOOK\DRIVERS\NT\VIDEO.40.
Using Windows NT 4.0
Installing Windows NT 4.0
5-5