Installing Windows 3.X; To Reformat The Hard Drive; To Install Ms-Dos - HP OmniBook 2000 Evaluator Manual

Installing Windows 3.x

This section describes how to set up the operating system and drivers including the
following:
Reformatting the hard drive.
Installing MS-DOS.
Installing Windows 3.1 or Windows for Workgroups 3.11.
Installing Windows 3.x device drivers.

To reformat the hard drive

1. Insert the MS-DOS Setup Disk 1.
2. Turn on the computer or press Ctrl+Alt+Del to reboot.
3. Press F3 twice at the MS-DOS Welcome screen.
4. At the MS-DOS prompt, type
format C:.
5. Follow the instructions as they appear.

To install MS-DOS

This section is not intended to replace your MS-DOS Documentation. Please refer to
your MS-DOS documentation for specific instructions.
1. Insert the MS-DOS Setup Disk 1.
2. Turn on the computer or press Ctrl+Alt+Del to reboot.
3. Press Enter at the MS-DOS Welcome screen.
4. Enter the requested information or press Enter to accept the defaults.
5. Follow the instructions as they appear.
6. Reboot when prompted.
Using Windows 3.x
Installing Windows 3.x
2-3