Setting Device Control Block Button And Trackball Operation; Setting The Macro Operation Mode - Sony XKS-C9111 User Manual

No. Parameter Adjustment
1 Ignore Time in which double-press is
Fields prevented (1 to 15 fields)
Setting Device Control Block Button
and Trackball Operation
In the Engineering Setup >Panel >Operation menu (7326),
press [Sensitivity] to open the Sensitivity menu (7326.5).
Configure each function, as required.
Setting the trackball and Z-ring sensitivity in
normal mode
In the <Trackball Normal Mode> group, select one of the
following.
×1: Standard (default travel speed)
×2: Move at 2× speed.
×4: Move at 4× speed.
Note
This setting is disabled in the following operation modes.
• Keyframe operation mode
• VTR/disk recorder/frame memory operation mode
Setting the trackball and Z-ring sensitivity in fine
mode
In the <Trackball Fine Mode> group, select one of the
following.
1/2: Move at 1/2 speed
1/4: Move at 1/4 speed
1/8: Move at 1/8 speed
Note
This setting is disabled in the following operation modes.
• Keyframe operation mode
• VTR/disk recorder/frame memory operation mode
Setting the sensitivity when recalling a menu
using button double-press
In the <Double Click> group, select one of the following.
Fast: High speed
Normal: Normal
Slow: Low speed

Setting the Macro Operation Mode

In the Engineering Setup >Panel >Operation menu (7326),
press [Macro] to open the Macro menu (7326.6).
Configure each function, as required.
Setting the macro execution mode
In the <Macro Execution Mode> group, select one of the
following.
Normal: Set normal execution mode.
Step: Set step execution mode.
Enabling simultaneous multiple macro execution
Press [Macro Multi Mode], turning it on.
Macro multi mode is enabled.
Setting button actions when configuring macro
attachments
In the <Attachment Setting Mode> group, select one of the
following.
With Btn Function: Simultaneously execute button
function.
W/o Btn Function: Do not execute button function.
Setting the action during macro execution or
when a macro is paused if the same macro is
recalled
In the <Macro 2nd Recall Mode> group, select one of the
following.
Continue: If the macro is recalled by operation of the
same button that executed a macro attachment, resume
execution of a paused macro or continue execution of
an executing macro as-is. If the macro is recalled by
any method other than a macro attachment, execution
starts from the first event.
Cancel: Stop the executing macro or paused macro.
Setting the action during macro execution or
when a macro is paused if another macro is
recalled
In the <Macro Recall Override> group, select one of the
following.
Disable: Ignore the other macro recall.
Enable: Stop the executing macro or paused macro, and
execute the other macro.
Note
When multi mode is enabled and macros are recalled using
buttons for which simultaneous execution is supported, the
settings in the <Macro Recall Override> group are
disabled. Other macros are also executed simultaneously.
Setting the enable/disable macro attachment
configuration mode
In the <Macro Attach Enable Setting Mode> group, select
one of the following.
Manual: Enable/disable using the [MACRO ATTACH
ENABLE] button on the cross-point pad of the cross-
point control block or the button assigned with the
"Macro Attachment Enbl" utility command.
Enable: Always enable macro attachments.
Disable: Always disable macro attachments.
Setting cross-point buttons with a macro
attachment to be lit continuously
Press [Attchd Btn Indication], turning it on.
When macro attachments for the cross-point control block
are enabled, cross-point buttons with a macro attachment
are always lit green.
433