Sony XKS-C9111 User Manual page 281

Applying a Drop Shadow
Depending on the combiner channel selection, the buttons
that can be used varies as follows.
Combiner Button
channel
Ch1 Ch2
selection
Shadow Shadow
Ch1+Ch2 Valid
Ch2+Ch3 Valid
Ch3+Ch4
Ch1+Ch2+ Valid Valid
Ch3
Ch2+Ch3+ Valid
Ch4
Ch1+Ch2+ Valid Valid
Ch3+Ch4
This section describes adding a drop shadow using Ch1
and Ch2 as an example.
1
Open the Global Effect >Ch1-Ch4 >Shadow menu
(4213).
2
Press [Ch1 Shadow], turning it on.
Drop Shadow is enabled, and channel 2 becomes the
channel for the shadow to the image.
You can adjust the position and density of the shadow.
Note
The flex shadow function cannot be enabled when
Drop Shadow is enabled.
3
Set the following parameters.
No. Parameter Adjustment
1 Position H Horizontal shadow position
2 Position V Vertical shadow position
3 Density Density of shadow
4
In the <Ch1 Shadow Source> group, select the shadow
signal.
Video: Select Ch2 video input as the shadow.
Flat Color: Select a single color matte as the shadow.
5
When [Flat Color] is selected in step 4, set the
following parameters.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
Ch3 Ch1+ Ch2+
Shadow Ch2 Ch3
Shadow Shadow
Valid
Valid
Valid Valid
Valid Valid
281
To combine images after applying a shadow
Select Ch1+Ch2 and Ch3+Ch4 using the combiner, then in
the Global Effect >Ch1-Ch4 >Shadow menu (4213), select
[Ch1 Shadow] and [Ch3 Shadow].
To apply a shadow after combining images
Select Ch1+Ch2+Ch3+Ch4 using the combiner, then in
the Global Effect >Ch1-Ch4 >Shadow menu (4213), select
[Ch1+Ch2 Shadow].