Device Control Block (Trackball) - Sony CCP-8000 Series User Manual

Device Control Block (Trackball)

The description below of frame memory
clip operations applies only to the MVS-
8000A/8000G.
The device control block is used for three-
dimensional transform operations using a
5 MENU button
a Region selection buttons
The operation mode allocated to the device
control block depends on the selection state
of the region selection buttons.
When the [M/E 1], [M/E 2], [M/E 3], and
[P/P] buttons are selected: This
enables the wipe pattern position
setting (positioner) operation mode in
the device control block. You can
select multiple buttons simultaneously.
When the [USER] button is selected: This
enables pattern position setting used
for color backgrounds.
62
Names and Functions of Parts of the Control Panel
DME, for wipe pattern position setting, and
for VTR/disk recorder/frame memory clip
operation.
1 Region selection buttons
2 Operating buttons
4 Z-ring
When the [DME1] to [DME8] buttons
are selected: This enables the three-
dimensional transform operation mode
in the device control block.
Press a button, turning it on, to select a
DME channel. You can select multiple
buttons simultaneously.
The number of valid buttons depends
on the number of DME processor
channels installed.
When the [DEV] button is selected: This
enables the VTR/disk recorder/frame
memory operation mode in the device
3 Trackball