Selecting The Bank And Keyer; Setting The Key Type; Selecting A Key Fill - Sony XKS-C9111 User Manual

The parameter assignment to the adjustment knob is
canceled, and the selected setting button changes color
from green to amber.

Selecting the Bank and Keyer

1
Press the delegation button for the target bank (M/E-1
to M/E-5, P/P), turning it on.
2
Press the delegation button for the target keyer (KEY1
to KEY8), turning it on.
The key control block is assigned to the selected keyer
on the selected bank.

Setting the Key Type

1
Press a key type selection button to select a key type
(see page 107).
[LUM] button: Luminance key
[LIN] button: Linear key
[CRK] button: Chroma key
[PTN] button: Key wipe pattern key
Pressing a button, turning it on green, displays the
parameter name and value of each parameter item on
the display.
Note
To use a color vector key or wipe pattern key, use the
menu (see page 110).
2
Set the following parameters, depending on the
selected key type.
When a luminance key or linear key is selected
No. Parameter Adjustment
1 CLIP Reference level for key signal
generation
2 GAIN Key sensitivity
3 DENSITY Key density
4 FILTER Filter coefficient
When a chroma key is selected
No. Parameter Adjustment
a)
1 CLIP Chroma key reference level
a)
2 GAIN Key sensitivity
a)
3 HUE Hue
4 DENSITY Key density
a)
5 FILTER Filter coefficient
a) Not displayed if [Key Active] is disabled in the Type >Chroma
Adjust menu for a key.
When key wipe pattern key is selected
No. Parameter Adjustment
1 SIZE
2 SOFT
3 DENSITY

Selecting a Key Fill

Set a key fill using the key fill/key source selection
buttons.
When using a color matte
Press the [PAGE] button to display the page 2/3 setting
buttons, then press the [MAT FILL] button.
The [MAT FILL] button turns on green, and displays the
parameter name and value of each parameter item on the
display.
When [Flat Color] is selected in the Type >Matte Adjust
menu, set the following parameters.
No. Parameter
1 LUM
2 SAT
3 HUE
When [Mix Color] is selected in the Type >Matte Adjust
menu, set the following parameters.
Parameter group [1/2]
No. Parameter
1 LUM
2 SAT
3 HUE
4 SIZE
5 SOFT
Parameter group [2/2]
No. Parameter
1 LUM
2 SAT
3 HUE
4 SIZE
5 SOFT
When using a key fill bus signal
Press the [PAGE] button to display the page 2/3 setting
buttons, then press the [MAT FILL] button, turning it off.
Using any of the following methods, select the key fill
signal.
125
Pattern size
Degree of edge softness
Key density
Adjustment
Color 1 luminance
Color 1 saturation
Color 1 hue
Adjustment
Color 1 luminance
Color 1 saturation
Color 1 hue
Pattern size
Degree of softness of pattern edge
Adjustment
Color 2 luminance
Color 2 saturation
Color 2 hue
Pattern size
Degree of softness of pattern edge