Saving And Recalling Setup Data; Selecting The Startup State - Sony XKS-C9111 User Manual

Saving and Recalling Setup Data

Local drive / removable drive
User setup data
Load
File menu
[Load]
Current setup data
(If in Resume mode, settings data is saved.)
Save
In Custom mode,
Setup
power on or reset
menu:
[Setup
Define]
Non-volatile memory
User setup data
Updating the switcher or control panel setup data saves the
updated setup data in RAM in each device.
• In Resume mode (see page 398), even if devices are
reset or powered off, the data is preserved in RAM, and
recalled when the power is turned back on.
• In Custom mode (see page 398), the user-defined
settings (user setup data) saved in non-volatile memory
is recalled when a reset occurs or power is turned back
on.
The setup data in RAM can also be saved to the local drive
or removable drive on the menu panel.

Selecting the Startup State

1
In the Engineering Setup >System >Start Up menu
(7314), select the target device to set.
2
In the <Start Up Mode> group, select the mode.
Resume: Resume mode (see page 398)
Custom: Custom mode (see page 398)
Note
[Resume] is enabled only when a switcher or control
panel is selected.
Save
File menu
[Save]
RAM
Initialize
Setup
menu:
[All Clear]
Non-volatile memory
Factory default setup
data
3
When [Custom] is selected, in the <Setup> group or
<Initial Status> group, select one of the following.
User: Set user-defined settings for the Setup or Initial
Status settings.
Factory: Set factory default settings for the Setup or
Initial Status settings.
4
Press [Execute].
5
Check the message, then press [Yes].
Restoring frame memory settings
You can configure restoration of frame memory settings at
startup.
The following settings can be restored.
• Memory status (loaded folder/file)
• FM output status (recalled file)
• Frame Memory >Clip/Still menu [Pair] and [Audio]
settings
• Frame Memory >Clip/Still >Play menu (2112) loop,
playback start point, and playback stop point settings
Notes
• This setting is available only when the target device is
the switcher.
• Restoration is not possible if the switcher signal format
is different from value in the saved settings data.
• Files that are not saved in frame memory storage cannot
be restored.
• If an FM output is locked, the lock is released and then
settings are restored.
1
In the Engineering Setup >System >Start Up menu
(7314), select the target device (switcher) to set.
2
Enable frame memory settings.
Resume mode
Press [Resume FM Status], turning it on.
Custom mode
Press [Init Status with FM], turning it on.
Note
In Custom mode, this is enabled only when Initial
Status is set to [User].
3
Press [Execute].
4
Check the message, then press [Yes].
399