Mask - Sony XKS-C9111 User Manual

4
In the <Zabton Pattern> group, select the pattern.
Key Wipe: Uses a key wipe.
Pressing [Pattern Select] opens the M/E-1 >Key1
>Transition/Video Process >Wipe Adjust
>Pattern Select menu (1117.2), allowing you to
select a pattern. Pressing [Pattern Adjust] opens
the M/E-1 >Key1 >Transition/Video Process
>Wipe Adjust menu (1117.1), allowing you to
adjust the pattern.
Key Edge Pattern: Uses a color mixing pattern for
key edge.
Pressing [Pattern Select] opens the M/E-1 >Key1
>Edge >Matte Adjust >Mix Ptn Select menu
(1112.2), allowing you to select a pattern. Pressing
[Pattern Adjust] opens the M/E-1 >Key1 >Edge
>Matte Adjust menu (1112.1), allowing you to
adjust the pattern.
Mask Pattern: Use the main mask source.
Pressing [Pattern Select] opens the M/E-1 >Key1
>Main Mask menu (1113), allowing you to select
[Box] or [Pattern] in the <Mask Source> group.
5
Press [Zabton Color] and adjust the color.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
4 Density Density

Mask

There are two masks, which can be used to mask off
unneeded parts of a key or background, or to remove
defects, and these are known as the main mask and sub
mask.
You can either use the main mask and sub mask
independently, or at the same time.
Using the main mask
1
Open the M/E-1 >Key1 >Main Mask menu (1113).
2
In the <Mask Type> group, select the mask type.
Key Mask: Masks a part of a key.
Bkgd Mask: Masks a part of a background.
3
In the <Mask Source> group, select the mask source.
Box: Signal from dedicated box generator
Pattern: Signal from dedicated pattern generator
4
Depending on the selection in step 3, set the following
parameters.
When [Box] is selected
No. Parameter Adjustment
1 Top
2 Left
3 Right
4 Bottom
5 Soft
When [Pattern] is selected
No. Parameter Adjustment
1 Size
2 Soft
5 Pattern
a) The patterns are the same as standard wipe patterns 1 to 24.
You can also make a pattern selection by pressing
[Mask Ptn Select] in the Main Mask menu to display
the Mask Ptn Select menu (1113.1).
Press the desired pattern (1 to 24) to select it, and set
the [Size] and [Soft] parameters.
5
To invert the mask source, press [Mask Invert],
turning it on.
6
When a pattern is selected as a mask source, set the
pattern modifiers as required.
When selecting [Position] and setting the pattern
position
No. Parameter Adjustment
1 Position H
2 Position V
a) See page 146.
When selecting [Multi] and replicating the pattern
No. Parameter Adjustment
1 H Multi
2 V Multi
3 Invert Type Pattern layout
a) See page 148.
When selecting [Aspect] and adjusting the pattern
aspect ratio
No. Parameter Adjustment
1 Aspect
a) See page 147.
120
Position of top side
Position of left side
Position of right side
Position of bottom side
Degree of softness of box
Pattern size
Degree of softness of pattern edge
a)
Pattern number
a)
Horizontal position
a)
Vertical position
Number of repetitions of pattern
horizontally
Number of repetitions of pattern
vertically
a)
a)
Aspect ratio