Table of Contents
Advertisement
128 | DRY 3.4 | Problem solving
2. To continue with the current (not identified) film pack, press the Confirm
button.
The following message is displayed:
3. Press the Confirm button.
• If the "Overrule RF-tag Reading" Setting is active, the following
• If the "Overrule RF-tag Reading" Setting is not activated, the following
4. Press the Confirm key again to resume printing using a limited Maximum
Density.
2604A EN 20180322 1454
Note: If you wish, you can try again to re-insert the current
or an other film pack. Press the Unlock button to initiate the
loading sequence. If you re-insert a film pack, the printer
will perform the check-sequence.
message is displayed:
message will be displayed:
Note: In this case, press the Confirm key to initiate the
loading procedure again or call your local service
organization to enable the "Overrule RF-tag Reading"
Setting.
Advertisement
Table of Contents
