Table of Contents
Advertisement
Capture Audio data from Audio CD (Capture function)
VS-1824 have function to capture Audio data from Audio
CDs.
This can capture audio from CD only in case the
sampling rate setting of current song is 44.1kHz.
If you are using a VS-1824 that is not
equipped with an internal CD-RW drive, you will need to
purchase a separately available CD-RW drive.
For instructions on connecting the drive, refer to "Connecting
an External CD-R/CD-RW Drive" (Owner's Manual p. 192).
PX-4220Te, PX-8220Te, PX-W124TSe, and PX-W1210TSE
manufactured by PLEXTOR is supported. In case you
are using other drives approved by Roland, consult with
your retailer, the nearest Roland Service Center, or an
authorized Roland distributor.
1. Load an Audio CD or CD-R/RW disc that contains audio
you like to capture on CD-RW drive.
2. Press [CD-RW/MASTERING].
CD-RW/Mastering Menu will appear.
3. Press [F6 (CDCap].
CD Capture screen will appear.
4. Press [
][
][
each of following parameters using TIME/VALUE dial.
If following cases, the tracks to capture audio must be set as
Stereo Pair. In case it is not set as Stereo Pair, a message of
"Illegal Track Pair!" appears and unable to capture audio.
• "CDR" is selected as recording mode of the current song.
• Any phrases in CD-R mode is recorded in destination
tracks.
L-Ch Dest Track (L channel destination track)
Select the destination track of audio to capture. Select the
destination track of left channel audio here.
R-Ch Dest Track (R channel destination track)
Select the destination track of audio to capture. Select the
destination track of right channel audio here.
*
In case the track which contain any phrases in CD-R mode is
selected as destination of "L-Ch Dest Track," it is impossible to
change "R-Ch Dest Track" with TIME/VALUE dial.
Capture TO
You can adjust the time of placement.
to ZERO:
Place the audio data starting at 00h00m00s00f.
to Last Phrs:0S:
Place the audio data after the end of the last phrase in the
destination tracks.
to Last Phrs:2S:
Place the audio data two seconds after the end of the last
phrase in the destination tracks.
to Last Phrs:4S:
Place the audio data four seconds after the end of the last
phrase in the destination tracks.
5. Once the above parameters are set, select the track of CD
shown under "CD Track" pressing [PREVIOUS] or
[NEXT]. The highlighted track is the target to capture.
CD Track
Select the track of CD shown under "CD Track."
Press [PLAY] to play the highlighted track.
When the cursor is in list of "CD Track," you can select track
of CD pressing [
][
][
]to move curser and set
].
Advertisement
Table of Contents
