Table of Contents
Advertisement
8. Make the settings for the effects.
Use [
], [
], [
cursor and the TIME/VALUE dial to adjust each of the
values. Press [F3 (FX A)] to make settings to EFFECT A
(FX1/2); press [F4 (FX B)] to make settings to EFFECT B
(FX3/4).
fig.02-21
Cursor
9. Press F2 (STEP
)]. You can return to the previous
screen by pressing [F1 (STEP )].
10. Decide whether or not to record the output of each effect
to a track. First, press the Effect SELECT button for Effect
1 or Effect 2, then press the STATUS button for the track
you want the effect recorded on. To select FX 3 or FX 4,
hold [SHIFT] and press the Effect SELECT button.
fig.02-22
Tracl to be recorded
11. Press [F2 (STEP
)]. You can return to the previous
screen by pressing [F1 (STEP )].
], and [
] to move the
Effect Switch
Send Level
Send Balance
Chapter 8 EZ Routing
12. Select mixer channels to be output to the AUX bus.
The AUX bus is useful for creating a separate headphone
mix for the performer you are recording. Use [
[
], [
], and [
TIME/VALUE dial to adjust each of the values.
fig.02-23
Cursor
13. Press [F2 (STEP
)]. You can return to the previous
screen by pressing [F1 (STEP )].
14. Select the Master Section settings.
Use [
], [
], [
cursor and the TIME/VALUE dial to adjust each of the
values.
fig.02-24
Monitor Select
Equalizer Mode
Direct Out
Effect Insert
15. Press [F4 (Exec)]. "EZ ROUTING Step Edit is finished!!"
appears in the display.
WARNING: EZ Routing settings will override any existing
mixer settings you have already made.
16. You can save your setup as an EZ Routing template, or
Exit [F6 (EXIT)] to leave this display without saving. To
save the setup, press [F3 (SAVE)]. The Routing Save
screen appears in the display. Save the setup using the
procedure described in "Saving an EZ Routing
Template," p. 123.
],
] to move the cursor and the
AUX Switch
AUX Send Switch
AUX Send Pan/Balance
], and [
] to move the
115
Advertisement
Table of Contents
