Saving Song Data To Dat (Dat Backup) - Roland VS-1824 Owner's Manual

24-bit digital studio workstation
Hide thumbs Also See for VS-1824:
Table of Contents

Advertisement

Saving Song Data to DAT
(DAT Backup)
Use the following procedure to back up song data on the
current drive.
1. Connect the VS-1824 and the DAT recorder as shown
below.
fig.09-02a
Optical
Digtal In
DAT recorder
fig.09-02b
Coaxial
Digital In
DAT recorder
Chapter 19 Using a DAT Recorder (DAT Backup)
2. Set the DAT recorder so it is able to record digital signals.
* Normally the sample rate at which song data is transmitted is
set to 48kHz. This sample rate has no relation to the sample
rate of the song data. If your DAT recorder requires you to set
the sample rate, set it to 48 kHz.
3. Hold [SHIFT] and press [F6 (UTILITY)].
The Utility Menu icon appears in the display.
4. Press [PAGE] so "DATBk" appears in the display above
[F6]. Press [F6 (DATBk)].
"DAT Backup Ready?" appears in the display.
5. Press [ENTER/YES] and "Store Current?" will be
displayed.
If you wish to save changes made to the current song,
press [ENTER/YES]; if not, press [EXIT/NO]
fig.09-03
6. Press [
cursor to "Source Song."
7. Use the TIME/VALUE dial to move the cursor to the
song you want to copy and press [F3 (MARK)].
By pressing [F2 (ALL)], you can place and remove marks
from all songs.
Press [F1 (SelSg)] to view a directory of songs. After
marking songs, press [F1 (Back)].
fig.09-03a
], [
], [
], and [
] to move the
239

Advertisement

Table of Contents
loading

Table of Contents