Table of Contents
Advertisement
Chapter 13 CD-RW and Mastering
4. Use [
], [
], [
cursor to "FXIns."
fig.2-19
5. Press [ENTER (YES)].
6. Use [
], [
], [
cursor. Use the TIME/VALUE dial to make your
settings.
fig.2-20.e
Effect Insert Switch
Insert Return Level
Insert Send Level
FX1 (effect insert switch 1)
Select how the effect will be connected.
Off:
The effect will not be inserted.
The stereo effect will be inserted into both
Ins:
channels. The inserted effects are shown as icons and as
patch names of up to ten characters.
Snd (effect send level)
Adjust the volume level of the signal that is sent to the insert
effect (-42–6 dB). The default is "0 dB."
Rtn (effect return level)
Adjust the volume level of the signal that is output from the
insertion effect (-42–6 dB). The default is "0 dB."
7. Press [F1 (FX1)].
8. Press [F2 (Sel)].
182
], and [
] to move the
], and [
] to move the
9. Use the TIME/VALUE dial to move the cursor to the
effect that you wish to use. For this example, select an
effect such as "P210 MTK:Mixdown."
fig.2-21
10. After selecting an effect, press [F4 (Exec)].
11. Press [F6 (EXIT)].
12. Press [FADER] so that the TR (track) indicator lights.
fig.2-07.e
Dark
Lit
13. Hold down [STOP], and press the STATUS button for all
tracks (1–12) that you wish to mix down.
The STATUS indicators will light green.
fig.2-06
14. Press [FADER] so that the TR (track) indicator blinks.
fig.2-07.e
Dark
Blink
15. Hold down [STOP], and press the STATUS button for all
tracks (13–16) that you wish to mix down. Press [PLAY].
The song will play back.
16. Raise and lower the master fader, and verify that the
volume of each track changes.
The sound that has passed through the master fader will be
recorded on the mastering tracks. In order to record at the
optimal audio quality, you will normally set the master fader
to 0 dB.
Advertisement
Table of Contents
