Table of Contents
Advertisement
Chapter 19 Using a DAT Recorder (DAT Backup)
2. Insert the tape that contains the song data into the DAT
recorder. If the song data is backed up on two or more
tapes, insert the first tape.
3. Rewind the tape to begin playback from the beginning of
song data.
4. Hold [SHIFT] and press [F6 (UTILITY)].
The Utility Menu icon appears in the display.
5. Press [PAGE] so "DATRc" appears in the display above
[F1]. Press [F1 (DATRc)].
6. Press [
] to move the cursor to "Digital In Select."
Use the TIME/VALUE dial to make the choice for
"Digital In Select."
Digital In Select
Select either "DIGIN1" (coaxial) or "DIGIN2" (optical).
7. Press [F2 (Verify)].
"Please Play DAT" appears in the display.
8. Put the DAT recorder in play.
The Verify process begins. If you have backed up data to
multiple tapes, the operation will suspend when the end
of each tape is reached. Insert the next-numbered tape as
indicated in the display, press [ENTER/YES], and start
the DAT recorder playing again.
9. When the verify procedure is finished, "Please Stop
DAT" appears in the display. Stop the DAT recorder and
press [ENTER/YES].
10. If there is no problem with the condition of the recorded
song data, "Complete" appears in the display. If a
warning message appears when the song data is loaded,
then that song data cannot be loaded correctly. If you
wish to check a tape again, insert the tape with the
number indicated in the display, press [ENTER/YES]
and play the DAT recorder. Press [EXIT/NO] if you
want to finish the procedure without checking the tape
again.
* To cancel the Verify operation, press [EXIT/NO].
244
Advertisement
Table of Contents
