Table of Contents
Advertisement
Chapter 10 Track and Phrase Editing
7. Press the Track STATUS button for the desired
destination track. The STATUS button turns red.
* If you want to select TR 1-12, press [FADER/MUTE] several
times until the "TR" indicator lights.
If you want to select TR 13-18, press [FADER/MUTE] several
times until the "TR" indicator blinks.
"Switching the Fader Functions" (p. 71)
8. Press [F1 (Back)].
9. Use [
], [
], [
and use the TIME/VALUE dial to set the parameters.
FROM (From Point)
You can specify the exact sync point of the phrase to be
moved as the FROM time. The FROM time will be
moved to the position designated as the TO time. You
can specify a FROM time that is not necessarily located
within the phrase. The destination of the Move is the TO
time.
TO (To Point)
You can specify the destination time of move as TO time.
156
], and [
] to move the cursor,
Quantize
If you set this to "ON", the TO time (destination time of
the Move) will be set at the beginning of the measure set
by the tempo map or sync track. For example, it's easy to
Move a phrase one measure when the phrase length is
2.0 seconds as when the tempo map setting is 120.
However, you will need a complicated calculation if the
tempo is 119.1. If you set Quantize ON, you can avoid
this.
Further, if this is set to ON, Overlap will be
automatically set to ON also.
10. Press [F4 (Exec)].
You cannot mix on one V track regularly recorded audio
with audio that has been recorded with the CDR Recording
Mode ON.
In Songs that use a Recording Mode other than "CDR"
follow these rules:
• Even on the mastering tracks, "CDR" V-tracks can only
be moved to V-tracks which already have been recorded
with "CDR" data, or to new V-tracks which have no data
recorded on them.
• V-tracks recorded within a song with a recording mode
other than "CDR" cannot be moved to mastering tracks
which are already recorded with the "CDR" recording
mode ON.
If the above rules are not followed, and the MOVE command
would mix CDR audio with regular audio, then "Found
Illegal Track Pair!" appears in the display and phrase move
cannot be executed. Please press [ENTER/YES] and select
the move destination again.
11. When the display indicates "Complete," press
[PLAY (DISPLAY)]. You will return to Play mode.
Advertisement
Table of Contents
