Table of Contents
Advertisement
12. DIGITAL Connectors (IN, OUT)
The VS-1824 accepts both coaxial and optical digital I/O
connectors (conforming to S/P DIF).
This accepts a stereo digital audio signal. You can
IN:
select either the coaxial input connection or the
optical connection.
OUT:
This outputs a stereo digital audio signal. You can
use both the coaxial connector and the optical
connector simultaneously, and each can carry a
different signal.
S/P DIF (Appendices p. 13)
* Before recording a digital audio signal, certain system settings
must be made. To input a digital signal, refer to "Recording a
Digital Source," p. 66
* The digital connectors cannot input or output analog audio
signals.
13. PHANTOM Switch
This turns phantom power (+48 V) on and off. With the
factory settings, this is set to "Off."
Phantom Power (Appendices p. 13)
* Supplying phantom power to dynamic microphones or audio
playback devices may result in damage to your equipment.
Thoroughly read the owner's manual of your microphone, and
make sure that the phantom power switch is set to "Off"
unless you are using a condenser mic that requires phantom
power.
* Switching the phantom power on or off while the VS-1824 is
turned on produces a loud noise that can damage amps and
speakers. Turn the phantom power on or off only when the
VS-1824 is turned off.
* When nothing is plugged into the INPUT 1–2 jacks, make
sure that the phantom power switch is set to "Off." Also, we
recommend that the INPUT knob be turned fully to "LINE" to
capture as high a sound quality as possible.
14. GUITAR (Hi-Z) Jack (Guitar)
This 1/4" phone-type high-impedance jack is designed to
work best with a guitar, for less interference and a louder,
cleaner signal. It can be used instead of—but not at the same
time as—the regular INPUT 8 jack. If cables are connected to
both the GUITAR input and the regular INPUT 8 jack, the
GUITAR jack will take priority. Use the INPUT 8 knob to
adjust the input sensitivity of this input.
Top and Rear Panels
15. 1/4" INPUT Jacks (3-8)
Inputs 3 through 8 may be used as 1/4" phone-type TRS (Tip
Ring Sleeve) balanced connections, or as 1/4" phone-type
unbalanced connections, depending on the jack and cable
used. Use INPUT knobs 3-8 to adjust the input sensitivity of
these inputs.
16. XLR Balanced Inputs
Inputs 1 and 2 are XLR balanced connections. Use INPUT
knobs 1 and 2 to adjust the input sensitivity of these inputs.
Front Panel
1
1. Disc Tray
Place the CD to be loaded on this tray.
2. Access Indicator
This indicator will light when the inserted CD is being read
or when data is being written to the CD.
3. Eject Button
This button opens or closes the CD disc tray.
4. Emergency eject hole
This hole allows the disc tray to be opened in case of an
emergency. See "If a disc tray does not open," p. 234.
It is strictly restricted to eject tray using emergency eject
hall during VS-1824 is operating. This is cause error of
software.
2
3
4
23
Advertisement
Table of Contents
