Table of Contents
Advertisement
3. Press [F6 (CDCap].
CD Capture screen will appear.
4. Press [
][
][
each of following parameters using TIME/VALUE dial.
If following cases, the tracks to capture audio must be set as
Stereo Pair. In case it is not set as Stereo Pair, a message of
"Illegal Track Pair!" appears and unable to capture audio.
• "CDR" is selected as recording mode of the current song.
• Any phrases in CD-R mode is recorded in destination
tracks.
L-Ch Dest Track (L channel destination track)
Select the destination track of audio to capture. Select the
destination track of left channel audio here.
R-Ch Dest Track (R channel destination track)
Select the destination track of audio to capture. Select the
destination track of right channel audio here.
* In case the track which contain any phrases in CD-R mode is
selected as destination of "L-Ch Dest Track," it is impossible
to change "R-Ch Dest Track" with TIME/VALUE dial.
Capture TO
You can adjust the time of placement.
to ZERO:
Place the audio data starting at 00h00m00s00f.
to Last Phrs:0S:
Place the audio data after the end of the last phrase in the
destination tracks.
to Last Phrs:2S:
Place the audio data two seconds after the end of the last
phrase in the destination tracks.
to Last Phrs:4S:
Place the audio data four seconds after the end of the last
phrase in the destination tracks.
][
]to move curser and set
Chapter 13 CD-RW and Mastering
5. Once the above parameters are set, select the track of CD
shown under "CD Track" pressing [PREVIOUS] or
[NEXT]. The highlighted track is the target to capture.
CD Track
Select the track of CD shown under "CD Track."
Press [PLAY] to play the highlighted track.
When the cursor is in list of "CD Track," you can select track
of CD pressing [
][
6. Press [F5 (Exec)] after completion all the settings.
A message concerning copyright appears in the display.
After reading this message, press [ENTER/YES].
The same message appears in the back cover of Owner's
Manual.
A message of "Capture to Mastering Tr. In CDR mode?"
appears in case of followings.
• 17 and 18 tracks * are selected as destination tracks and
• those tracks are selected as stereo pair and
• no song data exists on 17 and 18 tracks *.
*
This is applicable to 7 and 8 tracks instead of 17 and 18 in case
the Recording mode is "MAS."
Press [ENTER/YES] when you want to capture in CDR mode.
If you press [EXIT/NO], the recording mode of current song
will be applied.
If you find message "Illegal Track Pair!"
In the following cases, the tracks to capture audio must
be set as Stereo Pair. Unless, unable to capture.
• "CDR" is selected as recording mode of the current
song.
• Any phrases in CD-R mode is recorded in destination
tracks.
In this case, press [ENTER/YES] and re-set destination
track. (See process 4. above)
7. A message concerning Licensing Conditions is displayed.
After reading this message, press [ENTER/YES]. This
message appears in the back cover of Owner's manual.
A message "CD Capture.." appears on display and starts
capture.
8.
If you want to capture other audio data from same CD,
go back to process 4. above.
9. Press [PLAY (DISPLAY)] to return to the Playlist display.
].
193
Advertisement
Table of Contents
