Table of Contents
Advertisement
3.
Select <Edit> key to modify.
4.
Press "ESC" to go back action menu line
5.
Select <Apply> to apply all configure value.
Delete Filtering MAC address
1.
Press <Delete> to delete a Filtering MAC address.
2.
Choose the MAC address that you want to delete and then press "Enter".
3.4.7.3 Misc Configuration
You can configure the switch parameters.
MAC Address Ageing Time: MAC address table refresh time setting. Type the number of
seconds that an inactive MAC address remains in the switch's address table. The valid range
is 0, 300~765 seconds. Default is 300 seconds.
Broadcast Storm Filter mode: configure the broadcast storm filter mode. The valid
threshold values are 5%, 10%, 15%, 20%, 25%, and N/A. The port will be block cause of
broadcast packet is over the percentage of traffic.
Max Bridge Transmit Delay Bound: Limit the packets queuing time in switch. If enable, the
packets queued exceed will be drop. Press Space key to set the time. This valid value are
1sec, 2sec, 4sec and off. Default is off.
Low Queue Delay Bound: Limit the low priority packets queuing time in switch. If enable,
the low priority packet stays in switch exceed Low Queue Max Delay Time, it will be sent.
Press Space key to enable or disable this function.
Low Queue Max Delay Time: To set the time that low priority packets queuing in switch.
Default Max Delay Time is 255ms. The valid range is 1~255 ms.
Make sure of "Max bridge transit delay bound control" is enabled before enable
Note
:
Low Queue Delay Bound, because Low Queue Delay Bound must be work under "Max
bridge transit delay bound control" is enabled situation.
Collisions Retry Forever: Disable In half duplex, if happen collision will retry 48 times and
then drop frame. Enable - In half duplex, if happen collision will retry forever
Hash Algorithm: This Hash Algorithm is for hardware maintain on MAC table calculation.
Provide CRC or Direct Map
IFG compensation: Disable or Enable
Advertisement
Table of Contents
