Install The Switch - Planet Networking & Communication WGSW-2620P User Manual

2.1.2 Switch Front Panel
Figure 2-1 shows the front panel of the switch.
2.1.3 LED Indications
Network/PoE:
LED Color
PWR Green
PoE Green
LNK/ACT Green
FDX/COL Green
Gigabit:
LED Color
LNK/ACT Green
FDX/COL Green
2.1.4 Switch Rear Panel
Figure 2-2 shows the rear panel of the switch
Power Notice:
1. The device is a power-required device, it means, it will not work till it is powered. If your networks
should active all the time, please consider using UPS (Uninterrupted Power Supply) for your device.
It will prevent you from network data loss or network downtime.
2. In some area, installing a surge suppression device may also help to protect your switch from being
damaged by unregulated surge or current to the Switch or the power adapter.

2.2 Install the Switch

This section describes how to install the Ethernet Switch and make connections to it. Please read the
following topics and perform the procedures in the order being presented.
WGSW-2620PV front panel.
Figure 2-1
Function
Lights to indicate that the Switch is powered on.
Lights to indicate the port is providing 48VDC in-line power.
Lights to indicate the link through that port is successfully established.
Blink to indicate that the switch is actively sending or receiving data over that port.
Function
Lights to indicate the link through that port is successfully established.
Blink to indicate that the switch is actively sending or receiving data over that port.
Figure 2-2 WGSW-2620PV rear panel.