Aggregator State Activity - Planet Networking & Communication WGSW-2620P User Manual

When you had setup the LACP aggregator, you will see relation information in here.

4.7.5.2 Aggregator State Activity

When you had setup the LACP aggregator, you can configure port state activity. You can mark or
un-mark the port. When you mark the port and click
Opposite is Passive.
1. Active: The port automatically sends LACP protocol packets.
2. Passive: The port does not automatically send LACP protocol packets, and responds only if it
receives LACP protocol packets from the opposite device.
Note
:
1. A link having either two active LACP ports or one active port can perform dynamic LACP
Aggregator Information
Trunking - Aggregator Information interface
button the port state activity will change to Active.