Vlan Configure - Planet Networking & Communication WGSW-2620P User Manual

mode: VLAN Configuration, Create a VLAN Group, Edit/Delete VLAN Group and Group Sorted Mode.
Follow the below description to configure VLAN.

3.4.5.1 VLAN Configure

Before starting to configure VLAN, you must select the VLAN mode in VLAN Configure function.
Otherwise, user cannot create any new VLAN.
1. Select the <Edit>.
2. Select the VLAN mode by using "Tab" key. There are two VLAN modes: PortBase mode and
802.1Q mode. When select the 802.1Q VLAN mode, you need to configuration the following
settings.
802.1Q VLAN mode: configuration VLAN ID, Ingress Filter, and Acceptable Frame Type.
。
VLAN ID Range: Type the PVID. The PVID will only assign to the Ingress packets, not
for all packets.
Ingress Filter: It matches that Ingress Filtering Rule 2 on web. Drop untagged frame.
Press "Space" key to select drop or forward the untagged frame.
Acceptable Frame type: It matches that Ingress Filtering Rule 1 on web. Only forward
packets with VID matching this port's configured VID. Press "Space" key to choose
"forward" or "drop" the frame that VID not matching this port's configured VID.
3. Select <Apply> to apply the configuration.
When the VLAN mode changed that user has to restart the switch for valid value.
Note
:
VLAN Configuration Main interface