Port Commands Set - Planet Networking & Communication WGSW-2620P User Manual

Privileged
show
accounting
EXEC
User EXEC
show version
Privileged
show terminal
EXEC

3.3.2.2 Port Commands Set

Commands
interface
[FastEthernet
/module Ethernet]
[slot id] [id]
Show username &
password
Use the show version user
EXEC command to display
version information for the
hardware and firmware.
Use the show terminal
command to display
console information for the
switch
Command
Description
Level
Interface Use the fast Ethernet
configuratio
interface configuration
n mode
command
Switch# show
accounting
Username: admin
Password: admin
Switch> show
version
Firmware version:
1.0
Hardware version:
3.0
Kernel version: 1.10
Switch (config)#
show terminal
Baud rate (bits/sec):
9600
Data Bits: 8
Parity Check: none
Stop Bits: 1
Flow Control: none
Defaults Example
Switch (config)#
interface
fastEthernet 0/1