Qos Commands Set - Planet Networking & Communication WGSW-2620P User Manual

stp-path-priority
[Port Priority]

3.3.2.6 QoS Commands Set

Commands
qos storm-control
[5|10|15|20|25| off
(%)] or no
storm-control
qos
low-priority-delay-b
ound [on|off] [sec.]
or no qos
low-priority-delay-b
ound
Use the
spanning-tree
port-priority
interface
configuration
command to
Interface configure a port
configuratio priority that is used
n mode when two switches
tie for position as
the root switch.
Use the no form of
this command to
return to the
default value.
Command
Description
Level
Enable/Disable
broadcast storm
Global
control. Use the no
configuratio
form of this
n mode
command to
restore to default.
Enable/Disable
low priority delay
Global
board.
configuratio
Use the no form of
n mode
this command to
restore to default.
Switch (config)#
interface fastEthernet
0/2
128
Switch (config-if)#
stp-path-priority 127
Defaults Example
Switch (config)# qos
OFF
storm-control 5
Switch (config)# qos
OFF
low-priority-delay-boun
d on 1