Table of Contents
Advertisement
[t] Set Total Power Limit
[0] Exit
3.4.12 Save Configuration
You must save the configuration to the flash memory when you have changed the configuration.
Otherwise, the new configuration will be lost when the switch restart or power off.
3.4.13 Xmodem Upgrade
Before using Xmodem upgrade, disconnect terminal and modify baud rate to 57600bps, then connect
again.
1.
Press "X" key to start upgrading from Xmodem.
2.
You will see the following screen displays.
3.
Select "send file" under Transfer menu from menu bar.
4.
Select "browse" button to select the path.
5.
Select "1K Xmodem" of protocol and click "Send" button.
Set the total port power limit. When the Power
Management is enabling, this function will show
up.
Exit POE Menu mode
Save Configuration Interface
Advertisement
Table of Contents
