Table of Contents
Advertisement
Console Port Information interface
4.7.4 Port Controls
You can change the port status.
1
Select the port by scroll the list in Port column.
2
State: User can disable or enable this port control.
3
Negotiation: User can set auto negotiation mode is Auto, N-way (specify the speed/duplex on this
port and enable auto-negotiation), Force of the port.
4
Speed: set the speed of each port.
5
Duplex: set full-duplex or half-duplex mode of the port.
6
Flows Control: set flow control function is ON or OFF in Full Duplex mode.
7
Back Pressure: set Back Pressure is ON or OFF in Half Duplex mode.
8
Band Width: The port1 ~ port 8, supports port ingress and egress rate control. For example,
assume port 1 is 10Mbps, users can set it's effective egress rate is 1Mbps, ingress rate is 500Kbps.
The switch will perform flow control or Back Pressure to confine the ingress rate to meet the
specified rate.
In: fill in the port effective ingress rate. The valid range is 0 ~ 999. The unit is 100K. 0: disable
。
rate control. 1 ~ 999: valid rate value.
Out: fill in the port effective egress rate. The valid range is 0~999. The unit is 100K. 0: disable
。
rate control. 1 ~ 999: valid rate value.
9
Priority: this static priority based on port, if you set the port is high priority, income frame from this
port always high priority frame.
10
Security: when the port is in security mode, the port will be "locked" without permission of address
learning. Only the incoming packets with SMAC already existing in the address table can be
forwarded normally. User can disable the port from learning any new MAC addresses, and then use
the static MAC addresses screen to define a list of MAC addresses that can use the secure port.
Apply
11
Click
button to apply all configuration.
12
When you select the port, you can see port current configure shows in below.
Port Control interface
Advertisement
Table of Contents
