Table of Contents
Advertisement
3.4.2 Port Configuration
You can set up every port status.
1.
Select <Edit>
2.
Use "Tab/Backspace" key to move between items.
3.
State: Current port status. The port can be set to disable or enable mode. If the port setting is
disable then will not receive or transmit any packet.
4.
Negotiation: set auto negotiation function of port.
5.
Speed/Duplex: set the port link speed and duplex mode.
6.
FC: enable or disable Flow control function (Flow control for full duplex link mode).
7.
BP: enable or disable Back Pressure function (Backpressure for half duplex mode).
8.
Bandwidth In/ Out: per port packet transmission rate control. Per level is 100Kbps. It supports
individual control method of TX and RX.
9.
Priority: set packet of port to high or low priority queue.
10.
Security: enable or disable port security function.
11.
Select the <Apply>.
3.4.3 Trunk Configuration
You can configure port trunk group.
1.
Select <Edit>
2.
Using "Tab" key move to the port that want to be added as trunk group.
3.
Using "Space" key to mark the port.
4.
Using Tab key move to Trunk # (ex. Trunk1, Trunk2...) to change the Trunk # value to Static,
LACP, or Disable.
Port Configuration interface
Advertisement
Table of Contents
