Switch Setting - Planet Networking & Communication WGSW-2620P User Manual

can set the IP address back to its default IP address or you can reset the switch back to factory
default. And then you can enable the DHCP client function to work.
2. IP Address: assign the switch IP address. The default IP is 192.168.0.100.
3. Subnet Mask: assign the switch IP subnet mask.
4. Gateway: assign the switch gateway. The default value is 192.168.0.254.

4.7.2 Switch Setting

In Switch setting, it has three parts of setting - Basic, Advance, and Misc Config. We will describe the
configure detail in following.
4.7.2.1 Basic
In Basic switch setting, it displays the switch basic information.
System Name: the name of switch.
。
System Location: the switch physical location.
。
System Description: the description of switch.
。
Firmware Version: the switch's firmware version.
。
Kernel Version: the kernel software version.
。
Hardware version: the switch hardware version.
。
MAC Address: the unique hardware address assigned by manufacturer (default)
。
Module: the module information, if the switch doesn't install the module, then this column will
。
be no any information.
IP configuration interface