Mitsubishi MELSEC-Q Series User Manual page 65

2
SYSTEM CONFIGURATION
POINT
2.1.2 System configuration using High Performance model QCPU or Process CPU as CPU No.1
* 1: Only one memory card can be mounted. Select an appropriate memory card from the SRAM,
Flash and ATA in accordance with application and capacity.
When a commercial memory card is used, the operation is not guaranteed.
* 2: Use the Q series power supply module for the power supply module. Keep the current
consumption within the rated output current of the power supply module. The Slim power supply
module and Redundant power supply module are not available for the power supply module.
* 3: When the High Performance model QCPU is set to the control CPU of the AnS/A series module,
extension is allowed.
When the Process CPU or the Universal model QCPU is used, extension is not allowed.
The QA1S6 B, QA6 B, or QA6ADP+A5 B/A6 B is available for the AnS/A series compatible
power supply module, the I/O module and the special function module.
* 4: The Q Series power supply module is not required for the Q5 B extension base unit.
* 5: The motion CPU and PC CPU module do not accept battery for QCPU and memory card.
* 6: For further information on PC CPU module, consult CONTEC Co., Ltd Tel: +81-6-6472-7130
* 7: Be sure to set the control CPU of the motion module to the Motion CPU.
* 8: The PC CPU module and C Controller module cannot be mounted together.
* 9: When mounting the Universal model QCPU and the PC CPU module at the same time, use the
PPC-CPU852 (MS)-512 as the PC CPU module.
* 10: The Q02UCPU cannot be mounted.
The Universal model QCPU (except Q02UCPU) and the Motion CPU (Q172CPUN, Q173CPUN,
Q172HCPU, and Q173HCPU) cannot be mounted at the same time.
* 11: When the Q8BAT is used for the Universal model QCPU, use the connection cable whose
connector part displays "A".
For details of connector part of a connection cable, refer to the following manual.
QCPU User's Manual (Hardware Design, Maintenance and Inspection)
* 12: The QA6ADP+A5 B/A6 B is available. However, when using the QA1S6 B, the
QA6ADP+A5 B/A6 B cannot be connected.
When the multiple CPU system is configured using the High Performance model
QCPU or the Process CPU as the CPU No.1, only the following CPU modules can
be used as the CPUs No.2 to No.4.
• High Performance model QCPU
• Process CPU
• Universal model QCPU (except Q02UCPU)
• Motion CPU(Q172CPUN0,Q173CPUN,Q172HCPU,Q173HCPU)
• PC CPU module
• C Controller module
Note that the multiple CPU system cannot be configured using the following
combinations.
• Combination of the Universal model QCPU (except Q02UCPU) and the
Motion CPU (Q172CPUN, Q173CPUN, Q172HCPU, Q173HCPU)
• Combination of the Universal model QCPU (except Q02UCPU) and the
PC CPU module (PPC-CPU686(MS)-64, PPC-CPU686(MS)-128)
• Combination of the PC CPU module and the C Controller module
2.1 System configuration
1
2
3
4
5
6
7
8
2
- 12