Mitsubishi MELSEC-Q Series User Manual page 235

8
STARTING UP THE MULTIPLE CPU SYSTEM
(From previous page)
Writing parameter and
program to the Motion CPU
Writing parameter and program
to the C Controller module
Writing parameter and
program to the PC CPU module
RUN/STOP switch setting for all CPUs
Resetting CPU module of CPU No. 1
Confirmation of CPU module statues in all CPUs
Confirmation and correction of errors
Debug of each CPU module
Actual operation
Completed
* 1: For the Basic model QCPU and Universal model QCPU, it is the RUN/RESET/STOP switch.
For the Motion CPU and the PC CPU module, refer to the manual of each CPU module.
* 2: For the Basic model QCPU and Universal model QCPU, it is the RUN/RESET/STOP switch.
Diagram 8.1 Procedure to start multiple CPU system
8.1 Flow-chart for Starting Up the Multiple CPU System
Manual of the Motion CPU
Manual of the C Controller module
Manual of the PC CPU module
1
Set RUN/STOP switch * of all CPU modules to the RUN
position.
2
Set RESET/L.CLR switch * of the CPU module in CPU No.
1 to the RESET position to reset the entire system.
Refer to the following manual for RESET operation.
QCPU User's Manual (Hardware Design, Maintenance
and Inspection)
Check if all CPUs of the multiple CPU system are RUN
status/error by resetting the CPU module of CPU No. 1.
An error is checked with the system monitor of GX
Developer for correction.
Multiple CPU system is debugged for each CPU module.
1
2
3
4
5
6
7
8
8
- 2